Itzel Godínez-PhD Candidate-Advisor: Dr. Darnault

*The Analysis of the Behavior of Anthropogenic Nanomaterials in the Environment

To date, there are few studies that have analyzed the behavior of anthropogenic nanomaterials in the environment. However, the use of nanomaterials in commercially available products is rapidly increasing. As our society utilizes these nanosize materials in greater quantities, it is imminent that at some point they will be released into the environment either as waste and/or by accidental spills. Thus, it is crucial that scientific data is generated to explain the movement of nanomaterials in air, water and soil. The focus of my research is to investigate the fate and transport of two engineered nanoscale materials—single-wall carbon nanotubes (SWNT) and fullerenes (C60)—in the vadose zone under preferential flow. The objective is to develop non-intrusive, high spatial and temporal models to describe the transport of these nanomaterials in porous media. To assess the movement and behavior of SWNTs and C60 through the vadose zone 3D experiments, which consist of soil columns subjected to fingering and gravitational flow phenomena, will be implemented. The soil columns will serve to investigate the transport of SWNTs and C60 in unsaturated and saturated conditions as well as when undergoing wetting and drying cycles. A micromodel will also be employed to examine the fate and transport of these nanomaterials at the pore scale. The pore-scale visualization method is expected to provide information on the interactions of SWNTs and C60 with the air-water interface, the soil-water interface, and the soil-water-air interface. It is hoped that through the experimental results a comprehensive understanding on the transport of nanomaterials in porous media is elaborated.

I am a recipient of the Bridge to the Doctorate Fellowship at the University of Illinois at Chicago. I work under the supervision and guidance of Professor Darnault.

Burcu Uyusur, PhD Candidate, Advisor: Dr. Darnault

Nucleation and Precipitation Processes in the Vadose Zone during Contaminant Transport

Leakage has been determined in the vadose zone sediments of Hanford Site, U.S. Department of Energy Complex in Washington since 1950s. The site consists of high pH, high temperature and high ionic strength solution as well as radioactive elements such as uranium. The mode of transport of contaminants in the porous media, adsorption reactions, formation of secondary precipitates and colloids are important aspects for understanding the contaminant mobility in the environment of the site. This project aims to characterize and quantify the mechanisms of nucleation and precipitation of uranium secondary precipitates, specifically zeolitic and uranium-silicate in quartz sand and feldspar minerals under flow conditions. Both 3-D column and 2-D light transmission visualization experiments will be conducted under simulated unsaturated flow. The effluent will be analyzed for uranium, silica, etc. as well as colloids. Light transmission method will be used to quantify water content and solute concentrations in 2-D chamber. Surface analysis techniques such as BET gas adsorption technique and Atomic Force Microscopy (AFM), insight analysis such as Time Resolved Laser Fluorescence Spectroscopy (TRLFS) and Extended X-Ray Absorption Fine Structure (EXAFS) will be used to characterize mineral surfaces. The data will also be incorporated into a reactive transport model. The results can be of particular interest in terms of uranium reactions, particularly nucleation reactions of new phases and incorporation of uranium into these phases, with the quartz sand and feldspar during vadose zone flow. Also, the effect of these new precipitates on the flow of vadose zone sediments can be understood. Although the general emphasis is Hanford site, the conclusions are expected to be manageable for other similar field conditions.

Priscilla Viana- PhD Candidate-Advisor: Dr. Karl Rockne

*Active Capping for Sediment Remediation and Active Capping Potential in the Chicago River

I am working with active capping for sediment remediation. Active capping isolates contaminated sediments from the water phase offering continuous remediation and/or sequestration by the active material. The active material is chosen after an extensive site characterization. Bioaugmentation (addition of microorganisms), biostimulation (addition of amendments), use of sequestration additives (granular activated carbon, organo-clay, coke, and apatite) and hydraulic sequestration (water-expanding clay) are some proposed active capping amendment options.

Surface grabs and core samples were collected at Collateral Channel and at the turning basin of Bubbly Creek in the Chicago River (Chicago, IL). An extensive characterization of the solid and moisture content, organic matter and organic carbon content, and anion concentration (mainly nitrate and sulfate) was performed. This extensive characterization of the Channels was performed to assist choosing the correct active materials and thickness and gas controls in the design of a demonstrative active capping to be implemented at both Channels. Our group is collaborating with the Metropolitan Water Reclamation District of Greater Chicago, the Wetlands Initiative, and Patrick Engineering. Experiments to measure gas production rates along the Channels were completed and the effect of temperature in the reaction rate constant was determined using the Arrhenius equation for both Channels. Using this data we are able to predict the amount of gas that could be produced along each of the Channels through an entire year period and decide whether gas control systems will be necessary. The ratio of methane to carbon dioxide was measured in the sediment to observe the effect of temperature on methane production. Microbiological studies are being performed to quantify the levels of hydrogenotrophic and acetoclastic methanogens using quantitative polymerase chain reaction (qPCR) of 16S rDNA targets.

A mixed contaminant transport modeling for a variety of different active cap materials was also completed. I performed this work in collaboration with Ke Yin, also Dr. Rockne’s research assistant. These simulations are useful to understand the efficacy of selected cap materials and its thickness for containing and/or degrading organic and metal pollutant mixtures (five capping materials and 22 contaminants are being modeled).

A detailed evaluation of in situ processes that might compromise cap effectiveness is vital to guarantee cap effectiveness. We have identified gas ebullition due to methanogenic activity is one of the critical processes for cap release because bubbles are hydrophobic and tend to accumulate hydrophobic contaminants and colloids on their surface. Gas bubble migration may not only release contaminants to the water column and even to the atmosphere, but may also cause cap damage and even burst the cap, providing additional pathways for contaminant release. Studies quantifying contaminant release to the water phase due to gas ebullition are very limited. Thus, our future research will focus in understanding and quantifying the flux of contaminants through cap due to gas migration. We will also perform experiments to understand the microbial community involved in the gas production process to predict gas production rates, finding out values that would result in cap breach, with the goal of assisting the design of guidelines for site assessment and gas control measures.

*Ke (Ink) Yin, Ph.D Candidate, Advisor: Dr. Rockne

I am currently a Ph.D student in the department of Civil and Materials Engineering at the University of Illinois at Chicago under Professor Karl Rockne.

I am focusing on my research area on active capping potential for remediation of polluted sediments in the Chicago River, Collateral Channel, which has very high levels of polycyclic aromatic hydrocarbons (PAHs). With application of the Monti Carlo modeling of our contaminated site, we have found active capping effectively prevents PAHs from release for periods of decades to centuries. However, considerations regarding the placement technology, bioturbation need to be carefully taken care of during the design before the project’s complementation.

My goal is to try to apply several active capping materials and combined several placement technologies into our project design. We will build in an in-situ monitoring system to obtain a long term observation of the ongoing capping installation for our continuous research on capping efficiency. Comparison of our simulation result with the in-situ observations will validate the effectiveness of our modeling design, which will be very beneficial for a future project design and widespread application of the technology.

-- Main.sareva2 - 26 Aug 2010

Edit | Attach | Print version | History: r5 | r4 < r3 < r2 < r1 | Backlinks | Raw View | Raw edit | More topic actions...
Topic revision: r1 - 2010-08-26 - 16:31:26 - Main.sareva2
 
Copyright 2016 The Board of Trustees
of the University of Illinois.webmaster@cs.uic.edu
WISEST
Helping Women Faculty Advance
Funded by NSF